![]() |
|||||||||
![]() |
![]() |
![]() |
|||||||
![]() |
|||||||||
![]() |
|||||||||
![]() |
|||||||||
![]() |
||||||||||
| GRAB BARS | ||||||||||
Grab bars are considered essential for safety and are mandated by law in the United States. State handicap codes vary--check before ordering. Grab bars can be used as towel bars, but not vice versa. |
||||||||||
|
||||||||||
|
WingIts hold up to 1,000 lbs.! 1-1/4" and 1-1/2" diameter grab bars 12" to 48" lengths available Waterproof seal - incorporates 3M® VHB Tape No blocking or studs needed No need to tear open and reconstruct walls Can be installed in sheet rock, ceramic tile, tub surrounds, marble, and plaster Can be installed in all framed walls In sheet rock and ceramic tile, WingIts hold up to 1000 lbs. Quick 10 - 20 minute installation |
|||||||||
All WingIt products exceed government guidelines, federal, regional and local building codes and ADA criteria. To insure compliance, install in the proper location, see Americans with Disability Act Accessibility Guidelines (ADAAG) [http://www.access-board.gov/adaag/html/adaag.htm] Note: When ordering grab bars without WingIts, request 2" stainless steel screws - when required. Grab Bars come with 5 mounting holes per flange - WingIts use only the top & bottom holes. Grab Bars are available in 1" diameter - these do not meet ADA requirements. |
![]() |
|||||||||
![]() |
||||||||||
|
||||||||||
|
||||||||||